Table of Contents
Advertisement
Operation Guide
• Dimmable: This column defines if this parameter will be dimmed by Dimmer Faders and the Grandmaster.
• Type: If set to Fade, this parameter will crossfade, if set to Snap it will snap when changing values as opposed to a
smooth crossfade. This is particularly useful for parameters like Color or Gobo Wheels.
• Default: The 500ML console will output Default Values for a fixture if no other values that is output has been set
by the Playback or the Programmer.
• Blackout Values will be output once the Grand Master of the Console has been set to 0%.
• Highlight: Highlight Values will be output when the Highlight Button on the console's front panel is active. Usu-
ally Highlight temporarily sets the Dimmer Channel to 100% and removes all color and gobo information from a
fixture.
• Inverted: This defines if the DMX Values of this parameter will be inverted. Ie. Value 100 in the programmer will
be output as value 156. Default, Highlight and Blackout values still need to be entered in "Non-Inverted" form.
• DMX Min: This is the minimum DMX Value for this parameter that can be output.
• DMX Max: This is the maximum DMX Value for this parameter that may be output.
Note: If you select two parameter cells and press the [SET] key, the console will automatically assign the coarse
channel of the parameter to the first selected cell, and the fine channel to the second selected cell.
Select Parameter Menu
The Select Parameter Menu is used to select the Parameter mapped to a channel after pressing the [SET] key within a
parameter cell.
It shows a list of available parameters on the left hand side. This list may be filtered by entering the search string into
the Filter Text field in the top right part of the screen. You may further define the search by filtering by attribute
groups using the All, I, F, C or B buttons. Additionally, you may select to be shown Unassigned Parameters only, or
you may select to see All Parameters, even if they have already been added to a fixture type.
• The Coarse and Fine buttons may be used to toggle between the assignment of a coarse or a fine channel.
• Click on OK when done.
General Setup Mode
In General Setup Mode, the Fixture Manufacturer, Category (such as LED or moving light), Type (Fixture Name),
Short Type, Mode and Author Name may be set. Additionally, the Encoders are used to set minimum and Maximum
Pan / Tilt value in degrees.
1 5 0
Programming
Figure 273: Library Editor
500ML Lighting Control Console
Advertisement
Table of Contents
