Table of Contents
Advertisement
SUPERSERVER 2028GR-TR/TRT/TRH/TRHT Series User's Manual
6-5
Expansion Card Setup
The system supports the following PCI-Express expansion cards and an expansion
card bracket: Cards up to 10.5" in length are supported.
•
Four PCIe 3.0 x16 (2028GR-TR/TRT), or six PCIe 3.0 x16 (2028GR-TRH/
TRHT)
•
One PCIe 3.0 x8 (in x16) low-profile slot
Installing a Full-Height Expansion Card
1. Disconnect the chassis from any power source.
2. Confirm that you have the correct expansion card, riser card and expansion
card bracket for the chassis.
3. Remove the PCIe slot covers at the rear of the chassis.
4. Secure the riser card onto the bracket with screws.
5. Insert the expansion card into the expansion slot on the riser card.
6. Place the expansion card bracket into the chassis as shown on the following
page, while inserting the riser card into its appropriate slot on the serverboard.
7. Secure the expansion card bracket to the chassis with the three screws provided.
Low-Profile PCIe Slots
Figure 6-8. Rear Expansion Card Slots
6-8
Standard Size PCIe Slots
Advertisement
Table of Contents
