Installing And Adjusting The Base; With Latch Belts - ingenuity intrust 35 Instruction Manual

10. The base should sit flat.
• If the base is tilting, restart the installation process in
another seating location.
11. Close the vehicle belt positioner. Do not store the excess
LATCH belt strap underneath the vehicle belt positioner door.
12. Ensure the base is still level.
• If it is not level, readjust the recline angle.
13. Always ensure the installation is secure by attempting to move
the base (or seat if used without the base) by firmly pushing
and pulling the base at the location of the belt path. The base
or seat should not move more than 1 inch (2.5 cm) from side-
to-side and back-to-front at the location of the belt path. If
the base or seat moves more than 1 inch and/or the seatbelt
loosens or lengthens, try the installation again or utilize an
alternative method as detailed in your instruction manual.
14. Ensure no vehicle seats or doors interfere with the operation
or alter the position of the infant car seat or base. If
interference exists, start installation process over at step #1 of
this section.

5.3 Installing and Adjusting the Base

with LATCH Belts

LATCH systems provide a secure method for installing the infant
car seat base without using the vehicle seat belt. Consult your
vehicle owner's manual to see if LATCH is available in your
34