Downloading The Firmware From The Usb Memory - Kyocera FS-C5350DN Service Manual

2K8

(2) Downloading the firmware from the USB memory

To download data written in a USB memory to the printer, proceed as explained in this section.
CAUTION
Downloading firmware takes several minutes. Do not turn power off during downloading.
Procedure
1. Turn printer power off.
2. Insert the USB memory to the PC's USB
slot.
3. Copy the firmware file to download to the
root directory of the USB memory.
4. Remove the USB memory from the PC's
USB slot.
5. Insert the USB memory into the printer's
USB memory slot.
6. Turn printer power on.
7. When message display (1) is displayed to
detect firmware in the USB memory.
8. Message display (2) is displayed during
downloading.
9. When message display (3) is displayed to
indicate downloading is finished.
1-6-2
USB memory slot
USB memory
Figure 1-6-2
Message display
supervisor mode
(1)
supervisor mode
(2)
USB data reading
2K8_1000.000.024
(3)
[E1F9]
Product code
Firmware category
10: Engine
30: System
31: System (BROM)
Supplement (Normally: 00)
Classification (Normally: 0)
Update history
Build number
Checksum
Figure 1-6-3