System Tests; Setup Wizard; Gfci - Pentair Nuheat Signature Operating Instructions Manual

SYSTEM TESTS

The Nuheat SIGNATURE thermostat features
a series of diagnostic tests to confirm the
thermostat is installed and functioning properly.
The System Tests option is available the first
time the thermostat is connected to power or
after a factory reset is initiated.

SETUP WIZARD

The Nuheat SIGNATURE thermostat features a Setup Wizard to guide you through
the basic setup process.
The Setup Wizard is available the first time the thermostat is connected to power
or after a factory reset is initiated. Refer to section 6 on page 17.

GFCI

The Nuheat SIGNATURE thermostat has a built-in GFCI (Ground Fault Circuit Interrupter).
The GFCI protects against risks of electrocution caused by a current leakage. If the current
leakage exceeds 5 mA, the GFCI will automatically be triggered, thus cutting power to the
floor heating system. To indicate the fault, a message will appear on the screen informing
you of the fault. To reset the GFCI, press the button on the right side of the thermostat.
If problem persists, contact Nuheat at 1.800.778.WARM(9276).
Preview View
SIGNATURE OPERATING MANUAL
5