Section 4: Wifi Settings - Pentair Nuheat Signature Operating Instructions Manual

SECTION 4: WIFI SETTINGS

Section 4.1 WiFi Settings
From the home screen, access the WiFi Settings menu by pressing
Settings>WiFi Settings.
To connect your Nuheat SIGNATURE thermostat to your WiFi network:
1. Select your WiFi network from the list of available networks detected by the
Nuheat SIGNATURE thermostat. If the network name does not appear, refer to
section 8 on page
2. Enter the password for your WiFi network. Note upper/lower case letters, special
characters, and numbers in your password. Numbers and special characters can
be accessed by pressing the
3. Press Join.
4. The thermostat will now attempt to connect to your WiFi network. If this fails,
check your WiFi router and repeat steps 1 to 3. If problems persists,
refer to section 8 on page
5. Press Next once the screen says Connected.
6. Enter a name for your thermostat (eg."master bathroom" ).
7. Press Next.
8. Review the privacy policy available at www.nuheat.com and press Next.
9. Enter an email address where an activation email may be sent. Note upper/lower
case letters, special characters, and numbers in your email address. Numbers and
special characters can be accessed by pressing the
10. An activation email/link will be sent to the email address provided. Press OK.
11. Press Back to return to the home screen.
After 1-2 minutes, you will notice the WiFi icon turn on at the top of the home screen.
This means your Nuheat SIGNATURE thermostat is now connected to your WiFi network.
If you cannot connect to your WiFi network, refer to section 8 on page
for WiFi troubleshooting.
Preview View
19 for WiFi troubleshooting.
button.
19 for WiFi troubleshooting.
button.
19
SIGNATURE OPERATING MANUAL
15