Floor Limit; Screen Brightness; Screensaver - Pentair Nuheat Signature Operating Instructions Manual

SECTION 2: SETUP/PREFERENCES
Section 2.10 Floor Limit
Set the maximum temperature you want
the floor to reach. The floor heating will not
turn on if the floor temperature is above
the set floor limit. If the floor limit is set too
low, your floor heating system will not turn
on. Nuheat suggests leaving the floor limit
at the default factory temperature setting.
NOTE: This setting is not available if
Temperature Control is set to
Air/Room temp. Refer to section 2.6
on page 11.
Press Cancel to ignore the change or
press Save to confirm.
Section 2.11 Screen Brightness
Set the desired screen brightness.
Press Cancel to ignore the change
or press Save to confirm.
Section 2.12 Screensaver
The thermostat will display the screensaver
after two minutes of inactivity. You can
choose what information to display
on the screensaver.
NOTE: Weather information is only
available if the thermostat is connected to
your WiFi network.
Press Cancel to ignore the change
or press Save to confirm.
Preview View
IMAGE SOON
SIGNATURE OPERATING MANUAL
13