Table of Contents
Advertisement
. ' # ) A 9 # 8 # 5 9 ) $ D Q Q M T V R ' ' ' ' ' ' ' '
INITIAL SETUP (SETUP WINDOW)
B
Manual setting mode
1
Click the [MANUAL] address setting
mode select button in the REGISTER
DVR tab.
Manual address setting mode will be
selected.
2
Enter the "IP ADDRESS" setting
manually in the "NETWORK SET"
settings for the DVR.
Enter a number from "001" to "250" as the
last three digits of the IP address.
The setting method for IP addresses
varies depending on the model of the
connected DVR. Refer to the instruction
manual for the DVR for details.
3
Click
.
The buttons in the window will be locked
and creation of the registration list will start.
The time required for creating the list is
normally about 20 seconds, but it may
take up to about 80 seconds depending
on the subnet mask setting.
English
' ' '
4
List registration
The following details will be displayed in the
list, and the [CREATE LIST] button will be
automatically unlocked.
•
GROUP
•
DVR NAME
•
TYPE
•
IP ADDR.
•
MAC ADDR.
If a group name already exists for a
DVR, that group name will be retained
automatically for the DVR when manual
setting is carried out. Because of this, if
a group with the same name already
exists in the tree list, the DVR will be
added to the bottom of the list for that
group. If a group with that name does
not already exist, a new group with the
registered name will be created in the
list.
5
Change the DVR name and assigned
group.
You can change the initial settings if you
wish.
6
Click
.
This completes the address setting.
When setting addresses manually, be
careful not to duplicate the address
settings.
If you try to set an IP address that has
already been set for another DVR, a
duplication message will be displayed. If
you would like to proceed with entering
the duplicated IP address, the DVR
which was previously registered under
that IP address will be disconnected
from the network and the new DVR will
be registered instead.
25
(User Level: ID4)
Advertisement
Table of Contents
