Tap; Alarm (Tones/Vibration) - Epson RUNSENSE SF-810 User Manual

Tap

Tap the product screen to perform any of the following
functions. You can adjust these settings via the Tap
option in the Measure set. menu.
See "Measurement settings" on page 71.
Function
Lap Records the lap.
You can also record a lap by pressing D
while measuring.
Light Turns on the light. The light turns on for
approximately 10 seconds.
You can also turn on the light by
pressing B.
Screen Chg. Changes between the four
measurement screens.
You can also switch between
measurement screens by pressing A.
OFF* Turns off tap operations.
*indicates the default setting.
Note:
O The tap function may not work if you tap the screen
repeatedly. Make sure you leave a gap of
approximately one second between taps.
O When biking, the tap function may trigger due to
bumps in the road surface. Change the setting to
OFF when biking to prevent this.

Alarm (tones/vibration)

Your product can sound an alarm when certain
operations or exercises are performed. The following
table explains the meaning of each alarm depending on
the current watch mode.
Setting up your SF-810
Description
Mode
Chronograph When the lap is paused
Interval
When measuring is stopped
Goal
When measuring restarts
When you are off your target pace
When you have set multiple target
paces and the target pace changes
When you are outside of your HR Zone
Interval When switching between sprint and
recovery intervals
When the total number of sets is
reached
Goal When 50/90% of the set time or
distance is reached
When the set time or distance is
complete
Note:
O You can change the alarm tone or volume, or turn
the alarm off via the Alarm option in the System
set. or Measure set. menus.
See "Measure set. options" on page 72.
See "System Set. options" on page 76.
27
Alarm description