Disk - Panasonic WJ-ND400 Operating Instructions Manual

Disk

Use the following procedure to configure settings for operation when the HDD in the recorder becomes full. It also can be used to configure the
warning operation when the HDD becomes full.
1
Click the [Maintenance] button on the setup menu.
2
On the sub-menu that appears, click [Disk].
This will display the "Disk setting" window.
Disk settings
Item
Disk end mode
Normal recording area
Event recording area
Copy area
HDD capacity warning
Normal recording area
Event recording area
Copy area
Hour meter warning
♦Initial default
Settings
Continue♦
Continue♦ / Stop
Continue / Stop♦
Off♦ / 1% to 10%
Off♦ / 1% to 10%
Off / 1% to 10%♦
10000h / 20000h♦ / 30000h
3
Configure the settings for each item.
Refer to "Disk settings" table for details about the settings.
4
Click the [Set] button.
Description
When the normal recording area becomes full, the oldest data
is sequentially overwritten with new data.
Specifies operations when the event recording area becomes
full.
• When the event recording area becomes full while
[Continue] is selected, the oldest data is sequentially
overwritten with new data.
• When the event recording area becomes full while [Stop] is
selected, recording stops.
Specifies operations when the copy area becomes full.
• When the copy area becomes full while [Continue] is
selected, the oldest data is sequentially overwritten with new
data.
• When the copy area becomes full while [Stop] is selected,
copying stops.
Configures settings for warnings issued when the remaining
normal recording area reaches a specified value.
Configures settings for warnings issued when the remaining
event recording area becomes a specified value.
Configures settings for warnings issued when the remaining
copy area becomes a specified value.
Configures settings for warnings issued when the remaining
HDD operating time (hour meter) becomes a specified value.
Maintenance
79