Hosts - Panasonic WJ-ND400 Operating Instructions Manual

Hosts

The following procedure is to register information for PCs (hosts) that can access the camera over a network.
Up to 32 hosts can be registered.
1
Click the [User mng.] button on the setup menu.
2
On the sub-menu that appears, click [Host].
This will display the "Host setting" window.
Host settings
Item
Host IP address
Level
Access priority
Default screen
Camera partitioning
♦Initial default
Important:
• You must click press the [Set] button to activate settings on the recorder when registering, editing, or deleting hosts.
Note:
• Clicking the [Registration] button does not log out other users.
Settings
Address input (Blank♦)
LV1♦ / LV2 / LV3 / LV4
1♦ to 16
[Cam.1]♦ to [Cam.64] / [Cam.1-4]
/ [Cam.5-8] / to / [Cam.61-64] /
[Seq]
[View/Operate]♦ / [View] / [--]
3
Configure the settings for each item.
Refer to "Host settings" table for details about the settings.
4
Click the [Set] button.
Description
Enter the IP address.
• Enter single-byte numerals in the range of 0 to 255.
• You can use the "*" special character to represent any
number.
• "0.0.0.0" or "*.*.*.*" cannot be registered.
Specifies the user level.
• For operations that can be performed at each level, refer to
"User level (page 73)".
Specifies the priority sequence for operations when multiple
users are logged in on the recorder at the same time.
Specifies the live image display immediately after log in.
• Selecting [Cam.1] to [Cam.64] displays the images of the
selected cameras on a 1-image screen.
• Selecting [Cam.1-4] to [Cam.61-64] displays the live images
of the selected cameras on a 4-image screen.
• Selecting [Seq] displays images in a specified sequence.
Specifies the scope of control for each camera channel.
• When [View/Operate] is selected, live/recorded image
display or camera operation can be performed.
• When [View] is selected, live/recorded image display can be
performed, but camera operation cannot.
• When [--] is selected, neither live/recorded image display nor
camera operation can be performed.
User management
71