Panasonic WJ-ND400 Operating Instructions Manual page 57

Description of error
Other errors for HTTP
Move to Config
Camera SD memory card CAM cc SD ERR
error
Request to start writing on CAM cc SD START ERR
the camera SD denied
Request to finish writing on CAM cc SD END ERR
the camera SD denied
Request to obtain a data list CAM cc GET LIST ERR
on the camera SD denied
Request to obtain SD CAM cc GET IMG ERR
memory data on the camera
SD denied
Request to delete SD CAM cc DEL IMG ERR
memory data on the camera
SD denied
*1 HDD remove error is an error that occurs when the hard disk drive is removed without pressing the respective USE button.
*2 In the RAID 5 mode or the RAID6 mode, only "Error log" is displayed, but neither "Indication on the LCD" nor "Output from the connector on
the rear panel" is displayed.
*3 "HDD SKIP" is the function that continues recording even when an error occurs, such as an HDD write error, by recording images on the next
HDD.
*4 "Video loss" is an error that may occur between the WJ-NT304, WJ-NT314 and the camera connected to the WJ-NT304.To detect video loss
occurrences using the WJ-ND400, it is necessary to configure the "Panasonic alarm protocol " setting of the WJ-NT304, WJ-NT314, and the
"Site alarm " setting of the WJ-ND400.
Refer to page 58 for information on symbols used on the table above.
Error log Network log
<HTTP>OTHER_ERR
−
−
LCD
−
−
CONFIG
NW ERR CAMERA cc SD
−
ERROR
NW ERR CAMERA cc SD
−
ERROR
NW ERR CAMERA cc SD
−
ERROR
NW ERR CAMERA cc SD
−
ERROR
NW ERR CAMERA cc SD
−
ERROR
NW ERR CAMERA cc SD
−
ERROR
Error log
Output from
connector
Network error
output
−
Camera error
output
Camera error
output
Camera error
output
Camera error
output
Camera error
output
Camera error
output
57