Getting Started; Setup Procedure - Panasonic WJ-ND400 Operating Instructions Manual

Getting started

Initial configurations

Setup procedure

The procedure to start operations is shown below.
1
Rack Mounting
2
Connections
3
4
Installing HDDs
5
Recorder Network
6
PC Network Settings
7
Initialize HDDs
8
Camera Network Settings
9
10
Start Operations
When necessary
Replace HDDs
8
Power On
Settings
Settings
Mount the recorder into the rack (refer to the Installation Guide).
Go to step 2 if you are not using a rack.
Connect the recorder to the various devices (refer to the Installation
Guide).
Turn on the recorder (refer to the Installation Guide).
When using extension units, turn on all extension units before turning on
the recorder.
Install the HDDs in the recorder (refer to the Installation Guide).
Unformatted HDDs inserted into the recorder are automatically initialized.
Also, set the HDD operation mode as necessary.
Set the network for the recorder using the buttons on the front panel
(page 11).
This section explains how to change PC network settings to match the
settings of the recorder (page 13).
To change HDD area management, display disk configuration and
initialize the HDD from the setup menu on the recorder as needed
(page 86).
Open the NW camera setup menu from the PC and do the network
settings (page 48).
Set up functions necessary for operation (page 9).
You can change or format HDDs while the recorder is [ON] (refer to the
Installation Guide).