Contents........2 Thank you for buying a LG Fully Product feature......3 Automatic Washing Machine. Warnings Please read your owner’s manual Important safety instructions ....4 Save these instructions......4 carefully, it provides instruction on safe installation, use and maintenance. Specification ......6 Retain it for future reference.
roduct Feature Direct Drive System The advanced Brushless DC motor directly drives the drum without belt and pulley. Water Circulation Sprays detergent solution and water onto the load over and over. Clothes are soaked more quickly and thoroughly during wash cycle. The detergent suds can be removed more easily by the water shower during rinse cycle.
arnings READ ALL INSTRUCTIONS BEFORE USE For your safety, the information in this manual must be followed to minimize WARNING! the risk of fire or explosion, electric shock, or to prevent property damage, personal injury, or loss of life. IMPORTANT SAFETY INSTRUCTIONS WARNING : To reduce the risk of fire, electric shock, or injury to persons when using the washer, follow basic precautions, including the following: •...
arnings To minimize the risk of fire in a tumble dryer, the following should be observed: • Items that have been spotted or soaked with vegetable or cooking oil constitute a fire hazard and should not be placed in a tumble dryer. Oil-affected items can ignite spontaneously, especially when exposed to heat sources Such as in a tumble dryer.
pecification Shipping Bolts Power Plug Inlet Hose If the supply cord is damaged, it must be replaced by the manufacturer or its authorized Dispenser service technician in order to avoid a hazard. Control Panel Drum Back of Washer Cold Water Inlet Door Air Vent for Safety Hot Water Inlet...
nstallation Install or store where it will not be exposed to temperatures below freezing or exposed to the weather. Properly ground washer to conform with all governing codes and ordinances. The base opening must not be obstructed by carpeting when the washing machine is installed on a carpeted floor.
nstallation Installation place requirement Level floor : Drain Hose Allowable slope under entire washer is 1° Washer Power outlet : Must be within 1.5 meters of either side of location of washer. Do not overload the outlet with more than one Laundry appliance.
nstallation Electrical connection 1. Do not use an extension cord or double adapter. 2. If the supply cord is damaged, it must be replaced by the manufacturer or its service agents or similarly qualified person in order to avoid a hazard. 3.
nstallation Connecting water supply hose • Water supply pressure must be between 7.3 ~ 116 PSI (50 ~ 800 kPa). • Do not strip or crossthread when connecting inlet hose to the valve. • If the water supply pressure is more than 800 kPa, a decompression device should be installed. •...
nstallation Type-C : Connecting one touch type hose to tap without thread 1. Unscrew the adapter ring plate and the 4 adapter retaining screws. 2. Remove the guide plate if the tap is Ring plate too large to fit the adapter. Guide plate 3.
nstallation This equipment is not designed for maritime use or for use in mobile installations such as caravans, aircraft etc. Turn off the tap if the machine is to be left for any length of time (e.g. holiday), especially if there is no floor drain(gully) in the immediate vicinity.
• If possible install the washer in one of the corners of the room, where the floor is more stable. ※ ※ Insert the rubber cups to reduce vibration. ※ ※ Rubber cups ( p/no. 4620ER4002B ) can be purchased from the LG spare parts department. Important! •...
are before washing Before the first washing Select a cycle (COTTON 60°C, add a half load of detergent) allow the unit to wash without clothing. This will remove residues from the drum that may have been left during manufacturing. Caring before washing 1.
dding detergent Adding detergent and fabric softener 1. The Dispenser Drawer • Main wash only ➔ • Pre Wash + Main Wash ➔ 2. Adding Fabric Softener • Do not exceed the maximum fill line. Close the dispenser drawer slowly. Overfilling can cause early dispensing of the fabric softener which could stain clothes.
dding detergent ❋ Tips 3. Detergent dosage Full load : according to • The detergent should be used according to the manufacturer’s recommendation. instruction of the detergent manufacture. Part load : 3/4 of the normal amount. • If too much detergent is used, too many suds Minimum load : 1/2 of full load.
unction Recommended courses according to the laundry type Proper Temp. Additional Maximum Program Fabric Type (Option) Option Load Soak Pre Wash 40˚C Intensive Color fast garments (shirts, nightdresses, Normal (Cold, pajamas, etc) and normally soiled cotton Cotton Rating Light 30˚C, 60˚C) load (underwear).
ow to use washer • Water Temperature: Select water temperature to suit wash cycles. Always follow garment manufacture’s care label or instructions when washing. • Set program at “Cotton 40°C, Intensive, 3 Rinses, Extra High Spin” is for normally soiled load (10 kg) and test in accordance or in conformity with AS/NZS 2040.2.
ow to use washer (11) (12) (10) (1)Button: Power (4)Button: Wash (7)Button: Spin (10)Button: Dry (2)Dial: Program (5)Child lock (8)Tub Clean (11)Button: Steam (3)Button: Start/Pause (6)Button: Rinse (9)Button: Temperature (12)Button: Delay Wash Power Program 1. Power • Press the Power( ) button to turn power on and off.
ow to use washer Start/Pause Wash • By pressing the Wash button, the Wash type can be selected. 1. Start NOTE: Depending on the selected • This Start/Pause button is used to start program cycle, not all wash cycle or pause the wash cycle. Options may be selectable.
ow to use washer Child lock Rinse • By pressing the Rinse button, the Rinse type can be selected. If you choose to lock the buttons on the control assembly to prevent tampering, this function may be selected. • Child lock can be set by pressing and holding the Wash and Rinse button •...
ow to use washer Spin Water Temperature • By pressing the Spin button, • By pressing the Temp. the spin speed can be button, the water chosen. temperature can be selected. - Cold - 30˚C / 40˚C / 60˚C / 95˚C •...
ow to use washer Tub Clean Delay Wash Tub Clean Course can be set by pressing and Preparing washing before starting holding the Spin and Temp. button “DELAY WASH” simultaneously. (About three seconds) - Turn on the water tap. - Load laundry and close the door. TUB CLEAN is special cycle to clean the - Place the detergent and fabric softener in inside of the washer.
ow to use washer Steam Refresh I Refresh cycle • For slightly wrinkled clothes which have been stored for an extended time. It just makes wrinkled clothes easy to iron (Do not load wet clothes). • For tough stained clothes, underwear, or baby clothes.
ow to use washer NOTE 1.Drying Automatic guide The maximum drying capacity for this model is 7.5 kg. When loading, please • Use your Automatic Cycles to dry most loads. use the maximum drying capacity Electronic sensors measure the temperature indicator behind the door as shown of the exhaust to increase or decrease drying below.
ow to use washer 2.Drying time guide 3.Completion of Drying • By turning the Dry button, the drying time • Wrinkles and creases will form if the clothes can be selected. are not removed immediately after the drying is completed. •...
ow to use washer Display 3. Completion of washing • When washing cycle is completed, “ ” is displayed on the “Multi display”. 1. Special function display 4. Time left • When time delay is selected, it shows the • During washing cycle, the remaining washing remaining times to finish the selected time is displayed.
aintenance ❋ Before cleaning the washer interior, unplug the electrical power cord to avoid electrical shock to avoid electrical shock hazards. ❋ When disposing of the appliance, cut off the mains cable, and destroy the plug Disable the door lock to prevent young children being trapped inside. The water inlet filter - "...
aintenance The drain pump filter ❋ The drain filter collects threads and small objects left in the laundry. Check regularly that the filter is clean to ensure smooth running of your machine. CAUTION First drain using the drain hose and then open the pump filter to remove whatever any threads or objects.
aintenance Dispenser drawer ❋ After a while detergents and fabric softeners leave a deposit in the drawer. • It should be cleaned from time to time with a jet of running water. • If necessary it can be removed completely from the machine by pressing the catch downward and by pulling it out.
aintenance The water circulation nozzle & steam nozzle • Clean the water circulation nozzle, if clogged. Cleaning your washer 1. Exterior Proper care of your washer can extend its life. The outside of the machine can be cleaned with warm water and a neutral non abrasive household detergent.
roubleshooting guide ❋ This washing machine is equipped with automatic safety functions which detect and diagnose faults at an early stage and react appropriately. When the machine does not function properly or does not function at all, check the following points before you contact your service provider. Symptom Possible Cause Solution...
roubleshooting guide Symptom Possible Cause Solution Water in the washer • Drain hose is kinked or Clean and straighten the drain hose. does not drain or clogged. drains slowly. • The drain filter is clogged. Clean the drain filter. Washer does not •...
roubleshooting guide Symptom Possible Cause Solution • It takes time to balance the Wash cycle time The washing time may vary by the laundry before the spin cycle delayed amount of laundry, water pressure, water temperature and other usage conditions. If the imbalance is detected or if the suds removing program works, the wash time shall be increased.
roubleshooting guide Symptom Possible Cause Solution Check another tap in the house. • Water supply is not adequate in area Fully open tap. • Water supply taps are not completely open. Straighten hose(s). • Water inlet hose(s) are kinked. Check the filter of the inlet hose(s). •...