Neutral Brake "Ntbrk; Neutral Brake Function - FUTABA 4GRS Instruction Manual

Neutral Brake "NTBRK"

This is a function select switch dial function. The neutral brake function ON/OFF
switch must be set.
The neutral brake, which applies the brakes at the neutral position of the throttle stick,
can be set. However, when using the MC950CR, MC851C, MC602C, MC402CR, or
other Futaba MC (Motor Controller), confirm that the MC is in the neutral position and
the set is in the operation mode before setting the neutral brake function switch to ON,
the same as the idle up function. In addition, when the idle up function or throttle off
function is set, these functions have a higher priority than the neutral brake function.
Reference
The ESC neutral brake function and T4GRS neutral brake function can be used simul-
taneously. However, when setting is difficult to understand, we recommend that only
one neutral brake function be used.
Dial / Trim Setting
When the neutral brake function is
matically assigned to the throttle trim (DT1/2/3/4 or DL1).
Operation display
An LED blinks while the neutral brake function is active.
< NO SW >
I f f u n c t i o n 's O N / O F F
switch is not selected,
<NO SW> is displayed.
The function select switch
screen can be displayed
from this screen.
Neutral Brake function adjustment
(Preparation)
- Use the function select switch dial to select the switch.
1
(Neutral brake rate)
Select the setting item "NTBRK" using the (JOG) button. Use
the (+) and (-) buttons to set the neutral brake rate.
2
When completed, return to the MENU screen by moving the
cursor to the positions other than SW/DIAL and pressing the
(JOG) button
Effect of set value of other functions on neutral brake
Throttle side EPA function, or ATL function setting, also affects neutral brake side
operation.
90
*This function is not available in "TH-STK : F10 mode".
ON , the neutral brake rate adjustment is auto-
" "
If the power switch is
turned on while the neu-
tral brake switch is on,
an audible alarm will be
heard. Immediately set
the neutral brake switch
to OFF.
Throttle Mode "TH MODE"
Warning display
Adjust button
- Adjust with the (+) and (-) but-
tons.
- Return to the initial value "0" by
pressing the (+) and (-) buttons
simultaneously for about 1 sec-
ond.
Brake rate (NTBRK)
0 ~ B100
Initial value: 0