Power & Display Switch - FUTABA 4GRS Instruction Manual

Power & Display Switch
The power switch and display switch of the T4GRS are inte-
grated. In the PWR ON mode, radio waves are transmitted
and in the DISP mode, model data, settings can be checked
without transmitting radio waves.
In addition, some setting menus may only be displayed in
the DISP mode.
PWR ON
Radio waves are being transmitted
UP
MIDDLE
DOWN
Radio waves are not being transmitted
Precautions when turning the power switch on and off.
- When the data is changed using the edit buttons or trim levers, wait at
least two seconds before turning off the power. If the power is turned off
within two seconds after the data is changed, the new data will not be writ-
ten to memory.
- If the power switch is quickly switched from the DISP mode to the PW
ON mode or vice versa, the switch error shown at the right may be gener-
ated. If this occurs, cycle the power.
20
OFF
DISP
Power ／ DISP
Switch
LCD screen
When you do not run, turn OFF.
LCD screen
It cannot operate.