Telemetry Sensor Setting - FUTABA 4GRS Instruction Manual

Telemetry Sensor Setting

An audible alarm can be generated by the T4GRS from the data from a telemetry sen-
sor. This setting sets alarm ON/OFF and the alarm conditions.
Refer to the map on page 116 for the sensor setting (SENS MODE) screen display.
There are receiver power source (battery) voltage and external power source (drive bat-
tery) voltage settings on page 1 of the sensor setting screen and temperature and speed
settings on page 2. Pages 1 and 2 are switched by (JOG) button left or right operation.
Setting method
(Setting of each item)
Setting the receiver power supply voltage alarm
Display page 1 using (JOG) button left or right
operation.
Select "ALRM" of the "*RX VOLT" setting
items using (JOG) button up or down opera-
tion, and set alarm ON/OFF with the (+) but-
ton or (-) button.
"OFF" : Alarm OFF
"ON" : Alarm ON by a voltage drop below the specified voltage
Select "VOLT" of the "*RX VOLT" setting items using (JOG)
button up or down operation, and set the voltage at which
the alarm begins to sound with the (+) button or (-) button.
The number of digits can be shifted using (JOG) button left
or right operation.
When completed, move the cursor to [RT] using the (JOG)
button, and return to the HOME screen by pressing the (JOG)
button twice.
118
Receiver power sup-
ply voltage setting
Exter nal power
s u p p l y Vo l t a g e
Page1
sensor setting
Telemetry "TELEMETRY"
Temperature sensor
setting
RPM sensor setting
Page2
Alarm ON/OFF
ON, OFF
- Select with the (+) or (-) but-
tons.
Voltage alarm
3.8V~8.0V
Initial value: 5V
Adjust button
- Adjust with the (+) and (-) but-
tons.
- Return to the initial value "0" by
pressing the (+) and (-) buttons
simultaneously for about 1 sec-
ond.