Dual Esc Mixing "Dual Esc - FUTABA 4GRS Instruction Manual

Dual ESC Mixing "DUAL ESC"

This function is mixing used with crawlers and other 4WD type vehicles and uses the
2nd CH to control the front motor controller and the 4th CH to control the rear motor
controller.
Front drive only, rear drive only, or both front and rear drive can be selected using any
programmed DT (digital trim) button.
Setting Special mixings
When the 4th CH was set to ACT at Brake Mixing or when CPS Mixing is used, Dual
ESC mixing cannot be used.
Display "DUAL ESC" function screen by the following method:.
(HOME screen)
Dual ESC mixing adjustment
(Preparation)
- This function is used to switch between front
drive/4WD/rear drive using one of the dials
(trim). Set the desired dial (trim) for this func-
tion using the SW/DIAL screen.
1
(Dual ESC setting)
Select the setting item "MODE" using the (JOG) button up
or down operation. Set the function by pressing the (+) or (-)
button.
"INH" : Function OFF
"ACT" : Function ON
82
(MENU 1 screen)
Press
Press
Dual ESC mixing "DUAL ESC"
(MENU 2 screen)
Select
"DUAL ESC "
(Throttle system)
(DUAL ESC screen)
Press
Press
Setup items
MODE : Function ON/OFF
RATE : 4ch rate (Rear side)
MXMD : Mix mode
TRIM : Trim mode
Function SW
ESC-MD
The function select switch
screen can be displayed
from this screen.
Function ON/OFF (MODE)
INH, ACT
Select button
- Select with the (+) or (-) but-
tons.