4Ws Mixing "4Ws - FUTABA 4GRS Instruction Manual

4WS Mixes "4WS"
This function can be used with crawlers and other 4WS type vehicles. It is mixing which
uses the 1st CH to control the front axle steering and the 3rd CH to control the rear axle
steering.
OFF (front axle only), reverse steer, same steer, rear axle only and other 4WS type
switching is used by selecting SW1 with the function select switch function. If not se-
lected, <NO SW> is displayed. Therefore, select SW1.
Setting Special mixings
When the 3rd CH was set to ACT at Brake Mixing or when Gyro Mixing is used, 4WS
mixing cannot be used.
Display "4WS" screen by the following method:
(HOME screen)
Reverse steer
4WS mixing adjustment
(Preparation)
Since this function is used by switching the type of 4WS with
a switch, the switch used by the function select switch dial
function is set.
80
(MENU 1 screen)
Press
Press
Same steer
(Steering, 3rd channel system)
(MENU 2 screen)
Select
"4WS "
Rear axle only
4WS Mixes "4WS"
(4WS screen)
Press
Press
Front axle only
（4WS OFF）
Setup items
MODE ：4WS Type
RATE ：3ch rate (Rear side)
MXMD ：Mix mode
Function SW
4WS