Transferring Files From Flarm; Flarm Red Box / Mini Box Update; Flarm Pin Out; Lx Zeus And Garrecht - LXNAV LX Zeus Mobile User Manual

7.3 Transferring files from Flarm

Transfer of files from FLARM to Micro SD card is a very easy process. Micro SD card has to be inserted
into Micro SD port, which is found on LX ZEUS front panel. After the flight is finished wait for three
minutes, then turn LX ZEUS OFF and ON again. After switching on, a red POWER LED light on the
FLARM display blinking can be seen, all other LED lights are off. This means that all the flights that were
not already on the Micro SD card are transferring themselves. After the red POWER LED light stops
blinking, remove the Micro SD card and all the flight are there.
If the micro SD card has not been used for a while, FLARM will automatically transfer all flights that are
not already on the Micro SD card, from its internal memory to the micro SD card. If there are a lot of flights
to transfer, the process may take up to 20 minutes! Flarm will always store maximum 20 flights, so, if a
st
21 flight is recorded, then the oldest flight will be removed automatically.
The micro SD port is an extension of the FLARM system and settings cannot be changed via LX
ZEUS!

7.4 Flarm Red Box / Mini Box update

Flarm Red Box and Mini Box can be updated via SD card or PC by using Flarm Tool software. Read
update procedure at: www.lxnavigation.com
instructions.

7.5 Flarm PIN OUT

Bellow you can find information about pin out on Flarm connector – it is standard IGC connector.

8 LX ZEUS and Garrecht

Garrecht units can be simply connected to LX ZEUS without any software requirements. Declaration to
flarm will be sent directly from LX Zeus. Updating Garrecht units is not possible via LX Zeus. Connection
schematics are written bellow.

8.1 LX ZEUS and Garrecht TRX-1090 ADSB / TRX-2000

LX Zeus v 3.0
Note!
– section SUPPORT / MANUALS: LX Flarm update
25.6.2014
- 60 -