Clutch Inspection - Yamaha YW50AP Service Manual

V-BELT, CLUTCH AND
SECONDARY/PRIMARY SHEAVE
4-17
3. Loosen:
8 Nut(Clutch carrier)1
NOTE:
Install the secondary sheave to primary drive
shaft as shown, and hold the secondary sheave
by Universal Roter Holder 2 to loosen the nut
1.
Roter holding tool:
YU-01235
cC
Do not remove the clutch securing nut yet.
If the nut is removed without compressiong
the secondary sheave. It jumps and causes in-
jury.
4. Attach:
8 Clutch spring holder 1
Clutch spring holder:
YS-28891
5. Remove:
8 Clutch securing nut 2
6. Remove:
8 Clutch assembly 1
8 Clutch spring 2
8 Spring seat 3
8 Guide pins
8 Secondary sliding sheave

CLUTCH INSPECTION

1. Inspect:
8 Clutch shoes
Glazed parts→Sand with coarse sand-
paper.
NOTE:
After using the sand paper, clean of the pol-
ished particles with cloth.
ENG