Table of Contents
Advertisement
To move the upward or downward: Turn the
CHROMA knob.
5
Press the ENTER (Ent) button.
Part inside the cursor is magnified.
You can move the position of the magnified picture
with the PHASE knob or CHROMA knob. You can
change the magnification ratio with the UP or DOWN
button.
You can also change the boundary line color.
For details on changing the boundary line color, see
"Pixel Zoom Setting" (page 63) of the Display
Function menu.
Press the MENU button of the controller to return to
the cursor display.
To end the pixel zoom operation
When the cursor is displayed or the picture is magnified,
press the Pixel Zoom button of the controller.
90
Displaying the Picture in Black Detail Mode
Displaying the Picture in
Black Detail Mode
Black detail mode display function
You can reduce to dull black color by backlight leaking and
precisely assess any parts with low color gradation.
You can decrease the black level up to 40% of the normal
2
display (100 cd/m
at 100% signal). The parts with high
color gradation (higher than 75 IRE) are clipped by the
dynamic range of the circuit, but a zebra pattern
(selectable) is displayed in the clipped portions.
For details on the zebra pattern display for the clipped
portion, see "Zebra Pattern" (page 65) in the Black Detail
Setting menu of the Display Function menu.
Notes
• The setting is in effect when Gamma (transmission
gamma) of the Matrix/Gamma menu is set to 2.2 or 2.6
RGB.
• The contrast is not adjusted in black detail mode.
• The gamut error is not displayed in black detail mode.
• The signal is not displayed in black detail mode in the
following cases:
– When Interlace is set to On
– When Black Frame Insertion is set to On
– When H Delay/V Delay is set to On
For the Matrix/Gamma setting, see "Matrix/Gamma"
(page 53) of the Input Configuration menu.
To display the signal in black detail mode
Press the Black Detail Mode button* of the controller or set
Black Detail Mode to On in the Function Switch menu of
the Display Function menu (page 69).
The OVER RANGE lamp of the front panel is lit in black
detail mode.
* Black Detail Mode is assigned to the controller in the Function
Key menu (page 81) of the Controller menu.
Note
Use the controller with software version 1.3 or higher to
assign Black Detail Mode to the function button of the
controller.
Advertisement
Table of Contents
