Ducati Superbike 1199 Panigale Owner's Manual page 84

LAP recording (fig. 38)
If the LAP function is active, the lap time can be
recorded for a total of 30 consecutive laps.
Operation:
- when the FLASH button (3) is pressed for the first
time, the dashboard displays the lap timer with
resolution of a tenth of a second (0' 00'' 0);
- the next time the FLASH button (3) is pressed, the
dashboard displays for 5 seconds the number and
time for the just-ended lap, with a resolution of a
hundredth of a second;
- after these 5 seconds, the dashboard goes back
to lap timer page referred to the new current lap.
- if the FLASH button (3) (FLASH) is pressed for 3
seconds, lap timer is temporarily stopped and
display will show " 0'00''00 " and lap number
"LAP – –";
- the next time rider pushes the FLASH button (3)
or any equivalent control, lap timer is reactivated.
If the time is never stopped, it will roll over upon
reaching 9 minutes, 59 seconds and 99 hundredths;
the lap timer starts counting from zero and will keep
running until the lap is stopped or the recording
function is disabled.
Laps are numbered from 01 to 30 and are in a loop:
after the first 30 laps the dashboard will overwrite
information starting from Lap 01.
82
If the LAP function is interrupted (change to ROAD
layout or temporary disabling or key-off) and then
reactivated (back to TRACK layout or reactivation or
key-on) but memorized laps are not deleted, lap
information will be recorded by overwriting data of
the oldest Lap.
Example: if you rode 34 laps without deleting data,
the dashboard stores the first 30 laps and then
overwrites the first 4 laps. Upon the following key-on
or reactivation of the LAP function, if no data were
deleted, the dashboard will continue storing data
from Lap 05.
During every lap, the following data are stored:
- no. 30 lap times (time between consecutive start
and stop);
- no. 30 values for max. RPM (maximum RPM value
reached in every lap);
- no. 30 values for max. speed (maximum speed
value reached in every lap).