Ezm Group Options (Address 2600-2621) - NAPCO Gemini GEM-P3200 Programming Instructions Manual

WI1184B 2/06
EZM Group 1 EZM Group 2
ZONES 9-12 ZONES 13-16
ADDRESS 2600 ADDRESS 2601
LEFT RIGHT LEFT
blank blank
(•) (•)
Default depends on Easy Menu Question
"# OF ZNS IN AREA1
and "# OF ZNS IN AREA2
. For example, If 96 zones are used, then all 22 groups will be automatically enabled. If only 8 zones are used, then groups 1-22 will be
automatically disabled.
NOTE: Zones 1-8 are included in the control panel and Zones 9-32 (Groups 1-6) are EZM Zones (either Wireless or Hardwired).
Zones 33-48 are wireless only.
EZM GROUP OPTIONS: Up to 6 Groups of 4 Zones each may be programmed depending on the number of
EZM TYPE
zones used and which EZM modules are connected. Each group represents 4 zones.
DATA OPTION
ENTRIES
1. Select EZM type from the table shown.
RIGHT
blank (•) Not used
(No EZM 2. Enter in corresponding address locations above (right digit only).
present)
NOTE: Dark shaded data value box shows option not available.
1 4-Zone
EZM
EZM PGM TERMINAL CONTROL
AREAS 5-8
LEFT DATA VALUES
GROUP
)
(CIRCLE
NO.
A8 A7 A6 A5
8 4 2 1
1
8 4 2 1
2
8 4 2 1
3
8 4 2 1
4
8 4 2 1
5
8 4 2 1
6
[Default = blank (•) blank (•) from address 2622-2627]
EZM PGM ARMED TERMINAL CONTROL: For each zone group select the area(s) which, when armed, will activate the PGM Lug
on the corresponding EZM modules. Each zone group corresponds to 4 zones. If 8-Zone EZMs are used each one is treated as
TWO zone groups. NOTE: Lug goes ACTIVE (low) when ANY selected area is armed. When activated, the PGM Lug goes
negative (to Ground).
1. Select the desired group number.
2. Enable desired options for each area by drawing a circle
NOTE: No circle = feature disabled.
3. Enter data in corresponding left and right digit address locations above.
L
NAPCO Security Systems
EZM GR OUP OP TIONS (A D D R E S S 2 6 0 0-2 6 2 1)
EZM Group 3
ZONES 17-20
ADDRESS 2602
RIGHT LEFT RIGHT
blank
(•)
AREAS 1-4
ADDRESS
RIGHT DATA VALUES
2622-2627
)
(CIRCLE
A4 A3 A2 A1
L ADDR R
8 4 2
2622
8 4 2
2623
8 4 2
2624
8 4 2
2625
8 4 2
2626
8 4 2
2627
EZM Group 4
ZONES 21-24
ADDRESS 2603
LEFT RIGHT
blank
(•)
1
1
1
1
1
1
around its corresponding binary data value.
X
GEM-P3200 Programming Instructions
Page 53
EZM Group 5 EZM Group 6
ZONES 25-28 ZONES 29-32
ADDRESS 2604 ADDRESS 2605
LEFT RIGHT LEFT
blank blank
(•) (•)
RIGHT