Important Note; Changes From Previous Edition - NAPCO Gemini GEM-P3200 Programming Instructions Manual

THIS MANUAL INCLUDES FEATURES WHICH ARE ONLY AVAILABLE IN CONTROL PANEL FIRMWARE
VERSION 50 OR LATER.
This manual supports the keypad programming of the GEM-P3200 control panel with the NAPCO "classic" GEM-
RP2ASe2, GEM-RP3DGTL and GEM-RP4RFC/GEM-RP4C keypads as well as the GEM-K2AS, GEM-K3DGTL and
GEM-K4RF/GEM-K4 "K Series" keypads. The new "K Series" models offer the new STAY and AWAY buttons with sim-
plified functionality, along with the new MENU and ENTER buttons. While the instructions in this manual are depicted
using the "K Series" keypads, the manual applies to both the "classic" and the "K Series" keypads.
Program Mode is the same for both keypads--only the button names have changed, as follows:
A
• The
button and the
D
• The
button and the
• The
button and the
"NEXT/YES button" are used in this manual.
• The
button and the
"PRIOR/NO button" are used in this manual.
For consistency, it is recommended that all keypads either be all "classic" or all "K Series"--both keypad
types should not be used in one alarm system.
The following changes have been made to this manual (WI1184B) since the previous edition (WI1184A).
New addresses added to accommodate the GEM-ACM1D / GEM-2D Access Control Accessories, as follows:
•
ACM Zone Options (Address 2740-2779)
•
ACM Global Flags (Address 2780)
•
ACM Timeouts (Address 2782-2783)
•
ACM Door Area Options (Address 2784-2791)
•
ACM Scheduled Free Access (Address 4072-4079)
•
System Options (Address 2423)
•
Emergency Free Access (Address 4080)
•
Keypad Home Area / ACM Door #1 Area (Hex) (Address 2425-2439)
•
Addition to the Easy Program Menu instructions, "Enter Proximity Card Users".
Existing addresses were changed and new addresses were added to accommodate the NAPCO NetLink™ NL-Mod device, as follows:
•
(Address 0526, 0551 & 0576) For each telephone number desired, enable "Report to TCP/IP Receiver or AES" for Telco 1, Telco 2 and Telco 3.
•
(Address 1022) Enable "Callback Telephone No. Select". Enter either "1" for Callback Telephone Number 1 or "2" for Callback Telephone Number 2.
•
(Address 1027) Enable "Handshake for Local Telemetry".
•
(Address 2423) Enable "TCP/IP Communications".
•
(Address 2423) Enable "TCP/IP Panel/Site Initiated Functions".

IMPORTANT NOTE

R
button operate identically (in Program Mode) for both keypads.
U
button operate identically (in Program Mode) for both keypads.
button operate identically (in Program Mode) for both keypads. The words
button operate identically (in Program Mode) for both keypads. The words

CHANGES FROM PREVIOUS EDITION

NAPCO Security Systems, Inc.
333 Bayview Avenue, Amityville, New York 11701
For Sales and Repairs, call toll free: (800) 645-9445
For direct line to Technical Service,
call toll free: (800) 645-9440
Internet: http://www.napcosecurity.com