Star SP2000 Series Programmer's Manual page 44

N = 4 (ESC/POS mode)
n3 : Always "0"
Para. Setting
n1 RTS signal condition
n2 Receive buffer size
n3 DSR signal check
during setting status
transmission
6) N = 5
n1 : Always "0"
n2 : Always "0"
n3 : Always "0"
n4 : Always "0"
7) N = 6
n3 : Always "0"
n4 : Always "0"
Para. Setting
n1
Device ID (Parallel I/F only)
nPError signal (Parallel I/F only)
n2 Busy condition (Star mode only) *1
Treatment of missing data
during reverse mode.*2
"0" or "2" or "4" or "6" or "8" or "A" or "C" or "E"
"1" or "3" or "5" or "7" or "9" or "B" or "D" or "F"
n1 nPError signal
"0" to "7" Paper end sensor
"8" to "F" Paper end sensor and+ Paper near end sensor
"0" or "2" or "4" or "6" or "8" or "A" or "C" or "E"
"1" or "3" or "5" or "7" or "9" or "B" or "D" or "F"
42
"0" "1"
Save as Save as
DTR DTR
4 k bytes 4 k bytes
Checked Checked Not
n1
n2
"2" "3"
Always Always
SPACE SPACE
40 bytes 40 bytes
Not
Checked Checked
"0" to "F"
See below
Device ID
Invalid
Valid
Busy condition
Receive buffer
full or offline
Receive buffer
full