DataCard SD260L User Manual page 43

2.
Use the LCD menu system to start the cleaning cycle.
a.
Begin when the printer displays Ready and the U
button shows steady green. Press the U
Suspended displays on line 1 of the LCD panel.
b.
Press E
c.
Maintenance displays on line 2 of the LCD panel. Press
E to enter the Maintenance menu.
NTER
d.
Cleaning Card displays on line 2 of the LCD panel. Press
E to enter the Cleaning Card menu.
NTER
e.
Start displays on line 2 of the LCD panel. Press E
start the cleaning process.
f.
Insert cleaning card displays on the LCD panel. If the
cleaning card is not in the input hopper, insert it now.
Press the U
The printer moves the card through the printer several
times and ejects it into the output hopper.
3.
Remove the used cleaning card. Wait a few minutes for the rollers to dry.
4.
Prepare the printer for use.
a.
Replace the cards in the input hopper.
b.
Install a new cleaning sleeve on the ribbon cartridge and remove the protective cover.
Refer to "Load the Cleaning Sleeve" on page
SD260L/SD360/SD460 Card Printers User's Guide
to enter the menu system.
NTER
button to start the cleaning cycle.
SER
If you are cleaning an SD460 system, the cleaning card moves into the
laminator after cleaning the printer and cleans the laminator rollers and card
entry area. The cleaning card is ejected into the laminator output hopper.
Refer to "Clean the Laminator" on page
cleaning the laminator.
SER
button.
SER
to
NTER
A‐12 for complete information on
24 for the steps to follow.
31