Communication; Establishing Ethernet Communication - Honeywell Dolphin 75e User Manual

1. Install the battery in the terminal, see page 1-1.
2. Slide the Dolphin terminal into one of the four terminal wells. The Dock LED for the well illuminates blue. Charging
begins immediately if required by the Dolphin terminal.
Note: When the terminal is docked, the Battery Icon changes from
power. Battery charging occurs in the background. When the Dolphin is removed from the base, the battery icon
indicates the charge level of the battery, see
We recommend use of Honeywell Li-ion battery packs. Use of any non-Honeywell battery may result in damage
not covered by the warranty.

Communication

Establishing Ethernet Communication

Connecting the Dolphin Terminal to the Net Base
By default, the Dolphin terminal is configured to obtain IP addresses automatically via DHCP server. This means that
in most cases you would simply plug-and-play the unit.
1. Connect power to the Net Base (see
2. Plug the CAT-5 Ethernet cable into the RJ45 connector on the back of the Net Base.
3. Plug the Ethernet cable into the network.
4. Insert the Dolphin into the terminal well. The Dock LED for the well illuminates blue.
5. Touch All Apps
6. Check the box to Turn on Ethernet. When an Ethernet connection is established the status icon changes from
to at the top of the screen.
Troubleshooting
If the items on the Ethernet configuration screen are grayed out and not accessible, verify the base has power, the
Ethernet cable is undamaged and properly installed to the base, there is an active network signal over the Ethernet
cable, and the terminal is properly docked in the base.
Ethernet Configuration Settings
Instead of using the default DHCP assigned IP address, the Dolphin terminal can be configured to use a statically
assigned IP address.
1. Touch All Apps
2. Select Ethernet configuration, again.
3. Select Static IP under "Connection Type", then input the IP address and any additional information based on your
network configuration.
4. Touch Save.
Ethernet Proxy Settings
To set up a proxy to use when accessing your network with Ethernet:
Common Status and Notification Icons
Power on page 12-4).
> Settings > Ethernet configuration.
> Settings > Ethernet configuration.
to indicating the terminal is running on external
on page 1-7.
12 - 5