Honeywell Dolphin 75e User Manual page 14

Step 3. Power On the Terminal and Install Update
Important: Follow the power up instructions below the first time you turn On the Dolphin terminal.
1. Verify the terminal is either connected to an AC power source or the battery is fully charged.
2. Press the Power button. When the Honeywell logo appears and the right green LED turns On, press and hold both the
Volume Up and Home
Power (top)
If the terminal shuts down, repeat step 2.
3. Release the buttons when the green LED turns off. After approximately 30 seconds, the system update screen appears.
When the system update is finished, the lock screen appears (see page 1-5).
Once the initial update is complete, you do not need to repeat the above steps when powering up the terminal. You can use
the Power button to turn the terminal On. For more information on the power button functions, see page 1-10.
1 - 4
buttons at the same time.
Power
(top)
Volume Up
(side)
Volume Up (side)
Do not remove battery during update!