Configuring The Scan Demo Application - Honeywell Dolphin 75e User Manual

1. Slide the Automatic blue button to the ON position to enable the feature.
2. Touch Scan or press the Scan button to activate the imaging engine. Once activated, the imager automatically
scans and decodes bar codes presented in the field of view.
3. Touch Scan or press the Scan button to deactivate the imager.
4. Slide the Automatic blue button to the OFF position to disable the feature.
Continuous Scanning
Enable Continuous scanning mode to activate the imager for continuous scanning only when the operator touches
and holds Scan or presses and holds the Scan button. The time interval between scan attempts is minimal and not
configurable.
1. Slide the Continuous blue button to the ON position to enable the feature.
2. Touch and hold Scan or press and hold the Scan button to activate the imaging engine.
The imager scans and decodes bar codes presented in the terminal's field of view as long as Scan or the Scan but-
ton is pressed.
3. Release Scan or the Scan button to deactivate the imager.
4. Slide the Continuous blue button to the OFF position to disable the feature.

Configuring the Scan Demo Application

1. Open the Scan Demo application, and then press the Menu button
2. Touch Scan Settings, Symbology Settings, or Notification Settings.
3. Modify the settings to meet your application needs, and then press the Back button
screen.
Scan Settings
Touch the check box to enable or disable a feature. A check mark indicates enabled.
Setting
View Statistics
Auto Scan Delay
Auto Send
RF Configuration
Symbology Settings
For information on these settings,
Notification Settings
For information on these settings,
Description
When enabled, scan results displayed include the length of bar code, the
number of scans completed, the number of milliseconds (ms) to decode
the bar code, the average decode time of all the bar codes decoded, the
shortest decode time of all bar codes decoded, and the longest decode
time of all bar codes decoded.
Program the number of seconds between scan attempts by tapping the
menu arrow, and then entering the delay interval in second. The value
should be greater than 0 and less than 100000. Touch OK to save.
When enabled, decoded data is sent to a designated server.
Touch to view and/or edit the Server IP address and the Port used for RF
communication. When the Back button is pressed, the terminal attempts
to establish communication.
Symbology Settings
Notification Settings
.
on page 3-7.
on page 3-5.
to return to the Scan Demo
Default Value
Enabled
1
Disabled
3 - 7