Table of Contents
Advertisement
Figure 141. Media cage removal for four 3.5-inch hot-swap or simple-swap hard disk drive
server configuration
5. If you are instructed to return the media cage, follow all packaging instructions,
Replacing the media cage
Use this information to replace the media cage.
About this task
To install the media cage, complete the following steps:
Procedure
1. Read the safety information that begins on "Safety" on page vii and
2. Carefully push the media cage back into the server; then reconnect the cables
224
IBM System x3550 M5 Type 5463: Installation and Service Guide
Four 3.5-inch hot-swap or simple-swap hard disk drive server configuration:
and use any packaging materials for shipping that are supplied to you.
"Installation guidelines" on page 122.
that were removed from the system board. This may include the DVD drive,
front USB connector assembly, front video connector assembly, operator
information panel assembly, or LCD operating panel assembly cables.
Remember to insert the cables into the relevant cable clips and cable tie.
Note:
v Refer to the illustration that applies to your particular server configuration
v Remember the cable routing before disconnecting the cables from the system
board.
Eight 2.5-inch hot-swap or simple-swap hard disk drive server configuration:
Advertisement
Table of Contents
Troubleshooting
