Input Ac Power - Maximum Controls MAX MEGATRON 2500 Installation And Owner's Manual

input ac power

Remove and wire input AC power wire to the MAX PS-24 power supply as shown.
Choose either 115V or 230V setting on input AC power selector switch.
NOTE: AC power wire is required for EACH gate operator
when using dual gate operators.
CAUTION: MAKE SURE CIRCUIT
BREAKER IS OFF BEFORE WIRING
Input AC Power Options
Single Phase 115VAC Only
115VAC
Set to 115V
115 OR 230VAC
Power Wire
Single Phase 230VAC Only
230VAC
Set to 230V
Operator MUST be Properly GROUNDED
DO NOT remove any existing green ground wires.
Proper grounding of this
WARNING WARNING
gate operator is a
connect chassis
requirement for
to ground rod for
LIGHTNING PROTECTION
lightning protection
in lightning prone areas.
To be effective, ground connections should be made
with a minimum 12 AWG, 600 volt insulated wire to
a ground point within 10 feet of the gate operator.
The ground point must be at an electrical panel, a
metallic cold water pipe that runs in the earth, or a
grounding rod.
NOTE: Consult city codes for AC line wiring.
Beware of existing underground services.
Wiring operator
DANGER
HIGH VOLTAGE!
Power Terminal
Line (Black)
Neutral (White)
Chassis (Green)
IMPORTANT NOTE: Make sure there are NO exposed
bare wires at the power terminal connection.
2 3
0 V
Line (Black)
Neutral (White)
Chassis (Green)
Ground
within 10 ft
of operator.
4
S - 2
X P P L Y
M A U P
R S 4
S - 2
W E
P O X P P L Y
M A U P
R S
W E
P O
4
S - 2
A
U S
p l y
i n
d e
M a X P
u p
M A
A
U S
r S
i n
d e
M a
w e
P o
O N
O N
R
W E R
W E
P O
P O
F
O F
F
O F DO NOT
A C
A C
S E
F U
S E M P
TURN POWER
F U
I N 7 A
M P
I N
7 A
7 Amp
ON AT THIS
Fuse
TIME.
Input AC Power
Selector Switch
CAUTION: If power selector
switch is set for 115V but
input power is actually 230 V,
7 Amp Fuse will blow.
17