Cutting Height And Tilt Angle Adjustment - Husqvarna P 520D Operator's Manual

Cutting height and tilt angle
adjustment.
When a cutting unit is installed the cutting height and tilt angle
need to be adjusted
The adjustment must be made in the stated order.
Starting position:
1 Check the tyre pressures. The tyre pressure should be 1.5
bar/150 kPa/22 PSI for all wheels
2 Place the machine on a flat surface.
3 The cutting deck must be fully lowered on a level surface.
Cutting height - Combi 132, Combi 155
WARNING! Keep unauthorised persons at a
!
distance. You are responsible to ensure that
animals and onlookers are not within the
working area.
1 Position the machine on flat ground. Apply the parking
brake.
2 Raise the cutting unit halfway.
3 Turn off the motor. Adjust the cutting height by loosening
the handle and selecting the desired cutting height.
Cutting height (1-7) is indicated inside the adjusting plate.
The handle can be placed in different holes depending on
the cutting height. Set the same height on all three control
points.
4 Hand tighten the cutting height adjustment knob.
5 Adjust the control on the cutting unit. Remove the locking
pin and pull the control the required position. Set the same
height on all three control points.
Height intervals are in seven different positions.
Frequency Approximate cutting height mm/in
1 30 / 1,18
2 40 / 1,57
3 52 / 2,04
4 64 / 2,51
5 76 / 2,3
6 93 / 3,66
7 112 / 4,4
30 –
English
MAINTENANCE AND SERVICE
Tilt angle - Combi 132, Combi 155
• Place the machine on a flat surface.
• Check the tyre pressures. The tyre pressure should be 1.5
bar/150 kPa/22 PSI for all wheels
• Measure the distance between the ground and the front
and rear edges of the cutting unit hood.
• The rear edge of the cutting unit should be 6-9 mm (1/4"-
3/8") higher than the front of the unit.
• If necessary, loosen the lock nut and turn the adjusting
brace. Extend the brace to raise the rear edge of the
cutting unit.
• Tighten the lock nut against the ball joint.