Speed Limiter; Parking Brake; Rops (Roll Over Protective Structure) - Husqvarna P 520D Operator's Manual

Speed limiter

The speed of the machine is steplessly regulated with two
pedals. Pedal (1) is used to drive forwards, and pedal (2) to
drive backwards.
1
2
The machine is braked when the forward pedal is released.
The reverse pedal can also be used if additional braking
power is required.
Catch (P 525D)
1 Half speed catch.
2 Full speed catch.
3 Forward pedal
The forward pedal has a catch that can be foot operated.
When the catch is in full-speed position (2), the driver can fully
depress the forward pedal.
With the catch pulled back, the control goes to half-speed
position (1). The driver can then release the pedal and cut
uneven surfaces at a steady speed.
Accelerator check
• Ensure the forward and reverse pedals can be operated
freely.
• Ensure the machine brakes when the forward pedal is
released.
• Ensure the catch returns to full-speed position by lifting up
the forward pedal with your foot.
MACHINE´S SAFETY EQUIPMENT

Parking brake

Operate the parking brake by moving the handle forwards.
Checking the parking brake
Make sure the parking brake is properly adjusted by placing
the machine on a slope.
• Apply the parking brake.
• When the machine does not stand still, the parking brake
should be adjusted.
ROPS (Roll Over Protective
Structure)
ROPS is a protective frame that reduces the risk of injury in
the event of overturning. Use ROPS and a safety belt when
driving on slopes.
The frame can be folded down.
• Remove the two pins that hold the frame and fold it
backwards.
WARNING! If the frame is folded down the
!
safety belt should NOT be used.
– 11
English