Husqvarna P 520D Operator's Manual page 31

Cutting height - Combi 132 X, Combi 155 X
WARNING! Keep unauthorised persons at a
!
distance. You are responsible to ensure that
animals and onlookers are not within the
working area.
1 Position the machine on flat ground. Apply the parking
brake.
2 Adjust the cutting unit to the lowest cutting height and
lower the cutting unit.
3 Adjust the cutting height by depressing the button on the
adjustment bar and moving the bar forwards or
backwards. The height adjustment is variable.
4 The selected cutting height is indicated on the cutting
deck.
The adjustment bar raise and lower function depends on the
location of the hydraulic hoses in the quick couplings on the
machine.
• Test adjustment bar function by depressing the button on
the bar and moving it backwards and forwards.
• Switch the raise and lowering function by changing the
location of the hydraulic hoses.
MAINTENANCE AND SERVICE
Tilt angle - Combi 132 X, Combi 155 X
• Place the machine on a flat surface.
• Check the air pressure in the tyres The tyre pressure
should be 1.5 bar/150 kPa/22 PSI for all wheels
• Measure the distance from the front and back edge on
both sides of the deck to the ground.
• The rear edge of the cutting unit should be 6-9 mm (1/4"-
3/8") higher than the front of the unit.
• If necessary, loosen the lock nut and turn the adjustment
screw on both sides of the cutting deck. Extend the stay in
order to raise the front edge of the cutting deck.
• Tighten the lock nut against the ball joint.
– 31
English