To Set The Product To Off; To Charge The Battery; Cutting Height Adjustment - Husqvarna Automower Aspire R4 Operator's Manual

Note:
When the STOP button is pushed the product
will be idle. The product stops and the cutting motor
stops.

5.5 To set the product to OFF

1. Push the STOP button.
2. Push the ON/OFF button for 3 seconds to set the
product to OFF. Make sure that the LED indicator
goes out.
1
2 3 4

5.6 To charge the battery

When the product is new or after long-term storage, the
battery can be empty. Charge the battery before you
start the product. In the
cuts and charges automatically.
1. Push the ON/OFF button to start the product.
2. Put the product into the charging station until the
charging plates touch the contact plates.
3. Make sure that the LED on the ON/OFF button
pulsates.

5.7 Cutting height adjustment

CAUTION:
installation, set the cutting height to 3 to
26 - Operation
Main area mode, the product
The first weeks after a new
prevent damage to the loop wire. You can
then lower the cutting height each week.
You can select between 3 different cutting height steps.
The blade disc has marks for each step. Step 1 is the
lowest height, step 2 is the middle height, and step 3 is
the highest height. The factory setting is set to 3.
5.7.1 To adjust the cutting height
WARNING:
1. Push the ON/OFF button for 3 seconds to set the
product to OFF.
2. Make sure that the product is disabled. The LED
indicator on the ON/OFF button is not on when the
product is disabled. Refer to
3. Lift the top cover by the front and remove it.
4. Remove the torx key from the body of the product.
5. Put the product with the blade disc up.
6. Remove the 2 screws on the blade disc.
7. Remove the blade disc.
8. Select a cutting height and align the 2 holes on the
blade disc with the 2 holes on the shaft.
9. Attach the 2 screws on the blade disc to install the
shaft on the blade disc.
Use protective gloves.
Keypad on page 8 .
1886 - 001 - 01.02.2023