Setting The Cutting Height And Tilt Angle - Husqvarna PT-26D Operator's Manual

Maintenance

Setting the cutting height and tilt angle

When a new cutting unit is attached, you need to
adjust the tilt angle and cutting height.
Adjustment must be made in the stated order.
Starting position:
• Check the air pressure in the tyres 100 kPa / 1,0 bar /
14,5 PSI and 150 kPa / 1.5 bar / 21.7 PSI for the pivot
wheels.
• The cutting unit must be lowered on a flat surface.
IMPORTANT INFORMATION:
When replacing the cutting unit, you must readjust
the tilt angle and cutting height.
Cutting height
1. Release the cutting height setting handle.
2. Set the same height at all three setting points.
3. Tighten the cutting height handle by hand.
100
Right-hand cutting height adjustment
Left-hand cutting height adjustment
8043-046
8043-052