Restoring From Service Position - Husqvarna P 520D Operator's Manual

5 Lower the cutting unit to the lowest position. The cutting
unit now hangs free at the back.
6 Remove the universal drive shaft completely. Lift off the
lock chains.
7 Disconnect the hydraulic hoses from the quick
connections on the machine.
(Combi 132 X, Combi 155 X)
8 Remove the service strut from the cutting unit.
If it is the first time the service strut is removed, remove
the safety strap from the strut and place it in the storage
compartment under the seat.
9 Fit the service strut to the attachment under the base
plate. The attachment is highlighted in red.
10 Fit the other end of the strut to the attachment on the
cutting unit. Remove the pin and slide the strut across the
shaft which is marked red.
11 Release the pin so that it locks over the shaft.
12 Start the engine and raise the cutting unit to the service
position.
MAINTENANCE AND SERVICE
13 Secure the cutting unit with the safety belt, which is stored
in the storage compartment under the seat.

Restoring from service position

1 Remove the safety belt and place it in the storage
compartment.
2 Lower the cutting unit to the lowest position.
3 Remove the service strut and place it on the cutting unit.
4 Fit the universal drive shaft to the cutting unit. Secure the
front locking chain to the universal joint cover around the
cross pipe.
5 Start the engine. Raise the cutting unit halfway.
6 Fit the lifting eyes which are attached to the lift arms. Pull
out the catch and press in the lifting eye. There is one for
each lift arm.
7 Lower the cutting unit.
– 29
English