Fitting The Cutting Head - Husqvarna P 520D Operator's Manual

ASSEMBLING AND ADJUSTMENTS

Fitting the cutting head

1 Ride the machine to the cutting deck.
2 Lower the lift arms to the cutting deck attachment points.
WARNING! If the help function is engaged,
!
the lift arms will move with great force if
someone releases the lifting lever. Observe
caution to avoid trapping your hand.
Risk of crush injuries.
3 Activate the parking brake and turn off the engine.
4 Insert the bolts for the link joints and the pins on both sides
of the cutting deck.
5 Fit the universal drive shaft to the cutting unit. The
propeller shaft is marked with an arrow indicating the
direction in which it is to be connected to the power take-
off on the machine. Slide back the ring to release the quick
coupling and the universal drive shaft can be pushed onto
the shaft journal.
14 –
English
6 Secure the front locking chain to the universal joint cover
around the cross pipe.
7 Make sure the rubber casing is folded over the front
universal joint.
8 Remove the service hatch.
9 For more information, see 'Removing the ride-on mower
covers'.
10 Couple the rear of the propeller shaft to the power take-off
on the machine.
11 Fit the locking chain to the universal joint cover around the
lifting beam.
12 Refit the service hatch.
13 Start the engine and lift the cutting unit halfway up.
14 Turn off the motor.
15 Fit the lifting eyes which are attached to the lift arms. Pull
out the catch and press in the lifting eye. There is one for
each lift arm.
16 Check and adjust the tilt angle of the cutting unit. For more
information, see 'Cutting Height and Tilt Angle
Adjustment'.