Touchpad Reader; Changing Pin Code; Battery Replacement; Low Battery Indication - Mul-t-lock Entr User Manual

4. Touchpad Reader

4.1 Mounting the Touchpad Reader
Prior to starting, select the location where the Tochpad Reader is to be mounted.
• Attach the Touchpad Reader base plate to the wall.
• Use 4 screws and screw anchors or double sided glued tape.

4.2 Battery replacement

1. Release lid screw and open the lid
2. Put in the batteries (2xAA) according to the "+" "-" signs
3. Close the lid and tighten the screw
Notes:
• After inserting the batteries the Touchpad Reader will turn
on automatically
• A short beep sound emitted and Green [OK] indication
illuminated for 2 seconds.
Important: Do not touch the Touchpad during the self test
procedure and until the lights are off.

4.2.1 Low battery indication

Red warning signal blinking rapidly and long beep emitted on
every lock/unlock action.
Page 16
ENTR™ User Manual