Door Configuration - Mul-t-lock Entr User Manual

3.2 Door configuration

The Door Configuration process will determine the lock and door characteristics.
This process is done once after completing the installation process of the lock. It will take 15-20 seconds to
complete.
Important: Verify that the door is shut and no key is inserted into the cylinder prior to any configuration process
1
Touch screen with palm or fingers
for 3 seconds to active
5
The lock will carry out the
configuration process.
It will take 15-20 seconds to complete
Hold the door shut to avoid opening
ENTR™ on left side of the door
ENTR™ User Manual
2
Press [Cfg]
Configuration OK
[OK] Indication blinks once
2 short beeps emitted
Illuminated buttons turn off
Press [1]
3
Numeric buttons illuminated
Type [Pin code] [#]
1 long beep emitted
Configuration failed
[Error] indication illuminated
3 short beeps emitted
ENTR™ goes to menu mode
Start the process from stage 1
ENTR™ on right side of the door
Press [3]
4
Numeric buttons blinks
Press [1] or [3] to configure cylinder
side (see illustration)
Press [1] for left hand door
Press [3] for right hand door
Page 11