Trouble Codes - Everlast Powertig 255 EXT Operator's Manual

Section 4
TROUBLE CODE WITH WARNING LIGHT/UNIT
STOPS WELDING BUT IS TURNED ON.
801
802
804
805
OTHER
DIAGNOSIS
OVER OR UNDER VOLTAGE. Check power input cable for length/size, check input voltage. Running on poor
quality power supply or dirty power from generator.
OVER TEMPERATURE/ DUTY CYCLE EXCEEDED. Allow unit to rest for 15 minutes. Check for obstacles, clean
welder, and heat sinks. Make sure unit is unplugged for 30 minutes before opening up for cleaning.
OVER CURRENT. Check to make sure input power cable is correct length and size. Internal unit fault or low
input voltage. Possible issue running on generator with dirty power.
TORCH SWITCH IS STUCK CLOSED. Turn off welder immediately and check torch switch for stuck contact.
Check foot pedal for complete return or stuck micro-switch. Do not hold down the switch or pedal without
attempting to strike an arc. Doing so for more than 2 seconds without starting will cause this error code.
CONTACT EVERLAST
36

Trouble codes