Maintenance And Service; Maintenance Schedule - Husqvarna Rider Operator's Manual

Maintenance schedule

The following is a list of the maintenance which should be conducted on the machine. For those points not described in this manual,
visit an authorised service workshop.
Maintenance
Cleaning
Check the steering wires
Check the brakes
Check the battery acid level and condition.
Check the safety system
Check nuts and screws
Check the electrical cables and connections.
Check the cutting deck
Check the tyre pressures.
Lubricate joints, shafts and chain
Check/adjust parking brake
X = Described in this operator's manual
O = Not described in this operator's manual
WARNING! No service procedures must be conducted on the engine or cutting unit unless:
!
The machine is turned off
The ignition key has been removed from the ignition and the electrical cable is disconnected from the
battery terminal.
The parking brake is applied.
WARNING! Never wear jewellery, watches or similar when cleaning, carrying out repair work on or
!
inspecting the machine.

MAINTENANCE AND SERVICE

Daily
At least once a
maintenance
year
before starting
X
X
X
X
X
O
Maintenance interval
in hours
25 50 100 200
O
X
X
X
X
– 19
English