ASSEMBLING AND ADJUSTMENTS
Removing the cutting unit
To remove the cutting deck proceed as follows:
1 Position the machine on flat ground.
2 Turn off the machine and remove the ignition key.
3 Apply and lock the parking brake.
4 Check that the lever for setting the cutting height is in the
S position.
5 Lower the cutting unit.
6 Loosen the snap lock for the covers on the cutting deck
and loosen the cables. There are 2 for each motor.
7 Grasp the upper pipe framework in the cutting deck and
the cutting deck lock at the same time, and pull out the
cutting deck.
8 Lift off the deck and lean it against the machine or a wall.
Seat
The seat has a jointed attachment on the front edge and can
be tipped forward.
The seat can also be adjusted lengthways.
•
Loosen the bolts under the seat and adjust it forwards or
backwards to the desired position.
•
Tighten the bolts after adjusting.
– 9
English