Removing Of The Machine Hoods - Husqvarna Rider Operator's Manual

Removing of the machine hoods

Battery covers
The batteries are accessible for service when the battery
covers are removed. One battery is located in the rear
carriage and two batteries are located under the seat.
The two front batteries are located under the seat.
• Loosen the two snap locks, fold back the seat and remove
the cover.
• When fitting the cover, its hooks must be inserted into the
rear slots.
One battery is stored in the rear carriage.
• Loosen the snap locks (one on each side) and remove the
cover entirely.
• When fitting the cover, its hooks must be inserted into the
rear slots.
• Make sure the cover's guide pins align with the slots and
then close the snap locks.
MAINTENANCE AND SERVICE
Right-hand fender
• Remove the screws and the back pedal knob, and lift off
the cover.
Left-hand fender
• Loosen the screws holding the wing cover and lift off the
cover.
Protective cover
• Remove the protective cover by unscrewing the screws.
– 21
English