Card/Bracket Assembly - IBM IntelliStation Z Pro 6223 Hardware Maintenance Manual And Troubleshooting Manual

Card/bracket assembly

Note:
Complete the following steps to remove the card/bracket connector assembly:
1. Turn off the computer and attached devices.
2. Disconnect the power cord from the power source and from the computer; then,
3. Remove the side cover (see "Removing the side cover" on page 25.
4. Remove the front bezel (see "Removing the bezel" on page 26).
5. Press the latch on the top of the assembly; this side of the assembly will detach
6. Remove the tab on the bottom part of the assembly from the slot in the chassis.
7. Pull the assembly out slightly and detach the two cables from the back of the
To install the card/bracket connector assembly, reverse the previous steps, placing
the bottom tab into the slot in the chassis and then pressing the top of the
assembly into place.
v Read "Installation guidelines" on page 23.
v Read the safety notices at Appendix B, "Safety information," on page 125.
v Read "Handling static-sensitive devices" on page 23.
disconnect all external cables.
from the chassis.
assembly.
Chapter 5. Field replaceable units
69