Removing The Bezel; Installing An Adapter - IBM IntelliStation Z Pro 6223 Hardware Maintenance Manual And Troubleshooting Manual

Removing the bezel

When working with some devices, such as additional optical drives, you must first
remove the bezel to access the device. To install or remove options, you might find
it easier to lay the computer on its side.
Complete the following steps to remove the bezel:
1. Unlock the side-cover lock.
2. Remove the side cover (see "Removing the side cover" on page 25).
3. Locate the two bezel clips that are securing the bezel to the computer chassis.
For instructions for replacing the bezel, see "Replacing the bezel" on page 50.

Installing an adapter

The following notes describe the types of adapters that your computer supports and
other information that you must consider when installing an adapter. See "System
board option connectors" on page 71 for an illustration of the adapter slot locations.
v Read the documentation that comes with your operating system.
v Locate the documentation that comes with the adapter and follow those
26
IntelliStation Z Pro Types 6223 and 6227: Hardware Maintenance Manual and Troubleshooting Guide
Gently lift and hold the bezel clips up and at the same time, rotate the bezel
outward to disengage it from the side tabs; then, set the bezel aside.
Bezel clips
instructions in addition to the instructions in this chapter. If you need to change
the switch or jumper settings on your adapter, follow the instructions that come
with the adapter.