IBM IntelliStation Z Pro 6223 Hardware Maintenance Manual And Troubleshooting Manual page 46

10. Determine whether the drive is an IDE or SCSI device; then, connect one end
11. Route the signal cable so that it does not block the airflow to the rear of the
12. If you have another drive to install or remove, do so now.
13. Connect the power cable to the back of the drive. The connectors are keyed
14. If you have other options to install or remove, do so now; otherwise, replace
Installing a SCSI or SATA drive in bay 4, 5, or 6
Some models come with non-hot-swap SCSI hard disk drives or Serial ATA (SATA)
hard disk drives. Before you install a hard disk drive in bays 4, 5, and 6, read the
following information:
v Read the documentation that comes with the drive for cabling instructions.
v Route the cable before you install the drive. Do not block the airflow from the
v You can install up to four SCSI hard disk drives in your computer (SCSI models
v Your computer supports up to two Serial ATA hard disk drives.
v Install hard disk drives in this sequence: bay 4, bay 5, bay 6, and then bay 3.
36
IntelliStation Z Pro Types 6223 and 6227: Hardware Maintenance Manual and Troubleshooting Guide
of the applicable signal cable into the back of the drive and make sure that the
other end of this cable is connected into the applicable IDE or SCSI connector
on the system board.
drives or over the microprocessor and memory.
and can be inserted only one way.
the bezel (see "Replacing the bezel" on page 50) and replace the side cover
(see "Replacing the side cover" on page 51.
fans.
only).
Note: Your computer can support a third and fourth SATA drive if you install an
optional ServeRAID-7t S-ATA controller. In addition, if you install the
optional ServeRAID-7t S-ATA controller to add a third and fourth drive, all
four SATA drives must then be connected to the ServeRAID-7t S-ATA
controller instead of the system board. See the optional ServeRAID-7t
S-ATA controller documentation for cabling instructions.
If you purchase a new SATA hard drive, you will also need to purchase a
signal cable for it. IBM SATA hard drive option comes with a signal cable.
See "Installing a drive in bay 2 or 3" on page 32 for information about how to
install a hard disk drive in bay 3.