Firmware Upgrade; System Reset - Black Box 11N 2T2R Manual

11N 2T2R Wireless Access Point

4.2 Firmware Upgrade

To upload the most recent firmware to the access point, click Upgrade on the left of the Web management interface, and the fol-
lowing screen will be displayed:
Figure 4-2. Web upgrade screen.
Click on the Browse button, then you'll be prompted to provide the filename of the firmware upgrade file. Download the latest
firmware file from our website, and use it to upgrade your access point.
After you select a firmware upgrade file, click on the Apply button, and the access point will start to upgrade the firmware auto-
matically. The procedure may take several minutes.
NOTE: Never interrupt the upgrade procedure by closing the Web browser or physically disconnecting your computer from the
access point, since this could corrupt the firmware. If the firmware you uploaded is corrupt, the firmware upgrade will fail.

4.3 System Reset

If the access point is not working properly, use this function to restart the access point; this may help solve the problem.
This function is useful when the access point is far from you or unreachable. However, if the access point is not responding, you
may have to switch it off by unplugging the power plug and plugging it back in after 10 seconds.
To reset your access point, click Reset on the left, and the following message will be displayed:
Figure 4-3. System reset screen.
Click on the Apply button, and a popup message will ask you again, to make sure you really want to reset the access point:
724-746-5500 | blackbox.com
Page 52