Ap Bridge-Point To Multipoint Mode - Black Box 11N 2T2R Manual

11N 2T2R Wireless Access Point
Option
Channel Number
MAC address
Set Security
After you finish the settings, click on the Apply button, and the following message will be displayed:
When you see this message, the settings you made are successfully saved. Click on the Continue button to go back to the previ-
ous page and continue setting other items, or click on the Apply button to restart the wireless access point. The changes will take
effect after about 30 seconds.
3.4.4 AP Bridge-Point to Multi-Point Mode
In this mode, this wireless access point will connect to up to four wireless access points that use the same mode, and all wired
Ethernet clients of every wireless access point will be connected together. Use this mode to connect a network to other networks
that are physically isolated.
NOTE: When you set your access point to this mode, it will not accept regular wireless clients anymore.
When you select AP Bridge-Point to Multi-Point, the following screen will be displayed:
Page 28
Table 3-7 (continued). AP bridge-point to point mode options.
Description
Select a channel number you want to use. The channel number must be same as another wire-
less access point you want to connect.
Input the MAC address of the wireless access point you want to connect.
Click on this button to select an encryption mode for this wireless link, and a new popup win-
dow will appear. Please refer to Section 3.7 for detailed descriptions.
Figure 3-19. Settings saved successfully prompt.
Figure 3-20. AP bridge-point to multi-point mode screen.
724-746-5500 | blackbox.com